10/10 Boys Vape Not Hitting: 7 Fixes That Actually Work
Your 10/10 Boys Vape Not Hitting. Here are the 7 most common causes in order of likelihood, with an exact fix for each. Most take under 2 minutes to resolve.
Fix 1: Battery Needs Charging (Most Common)
The most frequent cause of a 10/10 Boys Vape Not Hitting, even on a new device. Liquid diamond oil is extremely thick, and the coil requires full battery power to heat it properly. A partially charged battery produces weak vapour or nothing at all, even with a full oil chamber.
Fix: Plug in via USB-C and charge for 30–45 minutes. Try again after a full charge. If the LED indicator changes colour or pattern after charging, the battery is the problem.
Fix 2: Device Is Still Locked
Most 10/10 Boys devices ship locked to prevent accidental activation during transit. A locked device produces no vapour even with a full battery.
Fix: Click the button 5 times rapidly to unlock. The LED will flash to confirm the device is now active. Try drawing again.
Fix 3: Oil Too Cold to Wick
D9 liquid diamond oil is extremely viscous. In cold UK conditions, particularly during winter mornings or after leaving the device in a cold environment, the oil thickens to the point where it cannot wick into the coil quickly enough to produce vapour. This is the most common cause of weak or absent vapour on a fully charged new device.
Fix: Double-click the button to activate the pre-heat function (10–15 seconds of low-heat warming). Alternatively, hold the device in your hand for 2–3 minutes before drawing. Always use the pre-heat function as part of your first daily draw routine.
Fix 4: Clogged Airway
Thick liquid diamond oil can migrate into the airway, particularly after horizontal storage or temperature changes. Symptoms: no airflow, or a gurgling wet sound when drawing.
Fix:
- Store the device upright and wait 10 minutes for oil to drain back into the chamber
- Cover the mouthpiece with a tissue and blow gently through the air intake at the bottom of the device — this pushes oil back into the chamber
- Draw again, starting with a short, gentle pull
Prevention: Always store your 10/10 Boys upright. Never leave it horizontal in a pocket or bag.
Fix 5: Mouthpiece Blockage
Oil residue or dust can partially block the mouthpiece opening, restricting or stopping airflow.
Fix: Look through the mouthpiece; you should see clear airflow. If blocked, use a thin pin or unfolded paperclip to carefully clear the opening. Do not push anything deep into the device. Wipe the mouthpiece with a dry cotton swab.
Fix 6: Burnt Coil From Chain Vaping
If the device produces vapour but tastes burnt or harsh, the coil may be overheated from drawing too frequently without allowing recovery time.
Fix: Wait 30–60 seconds between draws. The coil needs time to re-saturate with oil between uses. Never take more than 2–3 consecutive draws without a pause.
If the burnt taste appears on the very first draw of a brand-new device, contact us. This indicates a manufacturing issue.
Fix 7: Counterfeit Product
If none of the above fixes work on a brand-new device, the most likely explanation is that the device is not a genuine 10/10 Boys product. Counterfeit devices often have non-functional coils, empty or substandard oil, or hardware that simply does not work.
Check: Scan the QR code on the packaging. It must link to a batch-specific 10/10 Boys verification page. Read our complete verification guide for all checks.
Quick Diagnosis Table
| Symptom | Most Likely Cause | Fix |
|---|---|---|
| No vapour, no LED response | Dead battery | Charge for 45 minutes via USB-C |
| No vapour, LED lights up | Locked device or cold oil | 5-click unlock or pre-heat function |
| Gurgling sound, wet hits | Flooded airway | Nothing works on the new device |
| Weak vapour, good flavour | Low battery or cold oil | Store upright, blow through the base |
| Vapour but burnt taste | Chain vaping — burnt coil | Wait 60 seconds between draws |
| Nothing works on new device | Counterfeit product or fault | Verify QR code — contact us if purchased here |
Frequently Asked Questions
Why is my brand-new 10/10 Boys vape not working?
The three most common causes on a brand-new device: the device is locked (5-click unlock), the battery needs charging, or the thick liquid diamond oil is too cold to wick in UK temperatures. Work through Fixes 1–3 in order. If none work on a new device, check the QR code; it may be counterfeit.
Why is my 10/10 Boys making a gurgling noise?
Gurgling means oil has entered the airway, usually from storing the device horizontally or from a temperature change. Stand upright for 10 minutes and blow gently through the base air intake. Always store upright to prevent this.
Why does my 10/10 Boys taste burnt?
Chain vaping without recovery time between draws overheats the coil. Wait 30–60 seconds between draws. Never take more than 2–3 draws consecutively. If burnt from the very first draw on a new device, contact us or verify authenticity.
How do I use the pre-heat function on my 10/10 Boys?
Double-click the button rapidly. The device activates a 10–15 second low-heat warming cycle that thickens the oil just enough to wick into the coil properly. Use this every time you pick up the device after leaving it for a few hours, especially in cold weather.
→ Shop authentic 10/10 Boys — Official Store
→ How to verify your product is genuine
→ Explore all flavours